• single or multilayer ceramic tiles;
• synthetic laminate sheets;
• asbestos lumbers;
• thin, single or multilayer stone slabs;
• other materials with standard thickness from 6mm to 10mm;

• "CV1" extruded section in EN 6060 T5 aluminium alloy (or similar upon need);
• "V3et" and "V3" hooks to support sheets in EN 1.4310 (AISI 301) stainless steel;
• fixing springs of the hooks with "CV1" type "V2" section in EN 1.4310 (AISI 301) treated stainless steel;
• "A12" and "B12" standard bearing brackets made in EN 6060 extruded aluminium;
• fixing screws of "CV1" section to the brackets, stainless steel of Class A2;
• straight bracket to anchor small blocks to the wall support must be of mechanical or chemical resin type upon needs;
• neoprene band seal to be integrated with the sheets in respect of hooks and section of different thicknesses depending on needs;
• “Lana” hardened and tempered stainless steel springs for the support of the insulation SHEETS applied to the walls, if needed.

• wall fixing brackets screwed with stainless steel bolts with pitch as in the design;
• "V3et" and "V3" hooks for the sheet support and the related "V2" fixing springs to be applied by means of the suitable tool into the vertical rod groove, with pitch depending on the height of the covering sheet in addition to the design runout (which is invisible);
• the bearing springs of the insulating panel are release applied, if necessary.

The lack of drilling enables to not affect the superficial protection (oxidization or electrocolour) and to improve the life of sections.

The main characteristic of the "Venere Sormontato" system is that the sheets are mounted in semi-vertical position so that each upper sheet surmounts of about 1 cm the edge of the lower sheet and there are no open horizontal runouts. The sheets are mounted on the front side without any particular working on edges and/or on the backside and bearing hooks are visible from outside. If requested, hooks can be painted in the same colour of sheets to become almost invisible also from close.

The sheet is integrated with the frame by means of interposition of a neoprene seal with suitable thickness and the application of silicone points, if necessary.

Once laid, each sheet can be independently assembled and/or disassembled in respect of all the others.

The frame, which enables each type of adjustment, can contrast wind action and enables the thermal expansion of the different components.

• The standard structure is 110 mm plus the thickness of the covering sheets with a standard adjustment of ± 25 mm.
• The covering sheet standard thickness for this type of system is 6/10 mm.